"

亚博取现到账超快

"

Shenzhen Yongchang Xing Paper Co., Ltd.

Hotline:0755-29880806
简体中文

Industry information

Current position: Home > News> Industry information

Analysis of common problems in large paper box printing

Shenzhen Yongchang Xing Paper Co., Ltd. Hits:502 Publication time:2018-05-17 SmallmiddleBig

 Analysis of common problems in printing of large carton mills. In the process of making cartons in Shenzhen packing large carton factory, we can often change the quality problems of the dirty, paste or local graphic imprinting in the layout of the layout, and then we will say how to solve these problems.


large carton factory


  1、Quality defects caused by improper color sequence

  If the printed page is arranged in the same group, when the corrugated board is printed in the same group of printing, the printed board graphic and text ink is bad, the drying is slow, and the layout of the printed board is dirty. In order to prevent this disease, it is necessary to arrange small area layout in group color printing and arrange large area of the layout in the following color printing to avoid the dirty printing caused by transfer.

  2、Machine print quality failure caused by related components

  When the wear, loosening, pulsation, or sliding of the plate roll, the embossed roll shaft, the drive shaft, the gear and the embossing and the important parts cause the roll or the embossing roll in the printing process, the printing layout and the plate contact are not normal, the paste plate or the local cause of the graphic imprinting are not clear because of the pressure instability, and the printed surface of the cardboard is printed. Through careful observation and analysis, the exact location of the fault is found and the corresponding measures are taken to repair the parts of the worn and loose parts to eliminate the failure phenomenon.

  3、Quality failure caused by improper adjustment of pressure roller

  If the pressure roller is too high or too low so that the contact with the corrugated board is too tight or too loose, the dirty plate, the paste plate or the local graphic imprinting will not be clear. The press roll should be adjusted to the appropriate position, the gap between the roller and the roll and the suitable thickness of the plate, so as to ensure the production of the zero parts and avoid the failure phenomenon.

  4、The quality of the plate is not qualified because of the uneven thickness of the plate.

  When the thickness of the rubber plate is uneven, the layout of the board will be high or low. Where the area is high, it is easy to paste the plate, and the low area is easy to appear. It is not clear. In order to avoid the unfavorable situation, the scattered plate, by a number of small plates (in order to save the rubber plate and plate core plate technology), should produce the same block plate, so that its thickness difference is relatively small. If the rubber plate is ready, there is a thickness difference, which can make up the local thickness of the plate on the back of the plate so that the thickness of the plate is basically consistent, and the printing pressure and the uniform layout of the ink can be ensured.

  5、Fault caused by poor quality of roller

  When the roll shaft is loose and the upper roller is bent, deformed or damaged, it can also cause dirty pages, paste plates or partial graphics and text. We should find out the reasons and take appropriate measures to keep the contact between the cylinder and the printing plate unifying and appropriate, to replace the damaged rollers and to eliminate the failure.

  6、Six quality problems caused by uneven thickness of corrugated cardboard in large carton factory

  If the corrugated surface of the hollow trace is destroyed by human beings, the quality defects of the paper in the hollow part will appear. It is not clear that if the printing pressure compensation is added, the text line and the page quality will be stickable easily. In order to avoid the layout of the paste, corrugated cardboard should be light, light and light (to control the height of stacking) in the process of stacking and handling, and not to use bad production habits such as throwing, crushing, pressure and so on.

亚博取现到账超快